Hp spectre x360 keyboard not working series#

Badges: I used the little rubber clips as solder when I replaced a non-backlit keyboard for a backlit one on a pavilion x Hawkins Lee - July 23 Reply. Use the blue plastic tab on the ribbon cable to pull it out from the lock on the motherboard. Using the Heavy-Duty Spudger lift up the plastic locks connecting the ribbon cable to the motherboard. Disconnect the ribbon cables attaching the touch pad and keyboard to the system board motherboard. Raising the keyboard too far or with excessive force may cause damage to the keyboard, touch pad cables, or their connectors. Use the Plastic Opening Tool to separate the keyboard from the base of the laptop. Use a small amount of force when removing the keyboard. The keyboard is attached internally by clips. Turn the computer over onto its base, with the computer open and the keyboard facing upward. Make special note of each screw and screw lock size and location during removal and replacement. Use a Metal Spudger and remove the rubber foot closet from the bottom of the laptop. Badges: Hello, I'm the computer tech for a school, we have about HP Probook x 11 G1 EE, and often the key pop out and the hinge are broken, not the key.Time Required.Д«uy these tools. Remove the fifteen 3mm screws connected directly to the keyboard using the PH0 screwdriver. Pull the cable horizontally away from the motherboard to disconnect the speaker cable. Pull the cable horizontally away from the motherboard to disconnect the power connector cable. Pull the cable horizontally away from the motherboard to disconnect the power button board cable. Remove one 3mm screw using the PH0 screwdriver from the metal hinge located on the power connector side of the computer.ДЄfter the black tab has been flipped, pull out the blue cable to disconnect the keyboard cable. Remove the two screws from the metal hinge on the power button side using the PH0 screwdriver. Pull the hard drive slightly away from the connection to easily disconnect the hard drive cable from the motherboard. After the cable is slightly pulled from the connection, grab the cable and pull it outwards. Be careful not to pull the cable loose! Remove the battery cable from the motherboard by gently pulling out on the black part of the cable closest to the white tab. When you lift the bottom cover, there is a cable connected between the motherboard and the bottom cover. Pry around the seam of the laptop with the plastic opening tool until the backing begins to pull apart. Use the spudger to pry off the two rubber feet near the hinge of the laptop. Make sure your device is completely powered off and unplugged from any power source before beginning.

Hp spectre x360 keyboard not working series#

The steps in this guide should be split up and made into a series of prerequisite guides.